Loudspeaker - Metz 42TM92 Operating Instructions Manual

Mounting the plasma monitor on a wall
1. To mount the plasma monitor on a wall, first remove the stand (Fig. 1) by unscre-
wing the four screws (M5 x 20) which hold it to the monitor and pulling the stand
off.
The plasma monitor can be mounted on a wall with or without the loudspeakers
attached to it.
2. The wall mounting bracket is secured to the wall with four wall plugs (Ø10 x 50)
and four screws (Ø7 x 60) as shown in Fig. 2.
First select the position for the monitor. Hold the mounting bracket in a horizontal
position against the wall and mark the positions of the four mounting holes on the
wall. Drill four holes for the plastic wall plugs, insert the plugs and secure the
mounting bracket to the wall with four screws (Ø7 x 60).
3. Lift the plasma monitor and engage the two suspension screws on the rear of the
monitor with the matching holes in the wall mounting bracket.
Mounting the loudspeakers on the monitor
Place the plasma monitor face-down on a smooth, flat surface such as a table
(Fig. 3). Place the loudspeakers on the left and right sides of the monitor.
Align the loudspeaker brackets (two for each loudspeaker) with the holes in the plas-
ma monitor and secure each bracket with four screws (M5 x 12) to the loudspeaker
and the monitor. Connect the loudspeaker cables to the monitor.
RED
BLACK
1.1 Wall mounting
1.2 Loudspeakers
PLASMA MONITOR
LOUDSPEAKER BRACKET
RIGHT

LOUDSPEAKER

LOUDSPEAKER SOCKETS
LEFT
LOUDSPEAKER
SCREW
(M5 x 12)
57