Processor Installation; Cpu Cooler Installation - EMAC PCA-6782 User Manual

Table of Contents

1.10

Processor Installation

PCA-6782 series are equipped with soldered-down (BGA type) CPUs. no need for a

user to install a CPU.

1.11

Only PCA-6782D needs to have a CPU cooler installed by user (P/N:

1960046526N001), PCA-6782N does NOT require this; it already has a passive

heat-sink assembled on the CPU card.

PCA-6782D users please follow the instructions below to install the CPU cooler

which is included in the package.

First locate the Atom D525 CPU then put the metal plate included in CPU cooler

package onto the solder side of the PCB with its four legs inserted into these four

mounting holes around the CPU, then attach the CPU cooler onto the CPU card by

fastening the four screws, one into each leg of the metal plate. Fasten the first screw

loosely, then loosely engage the second screw diagonally across from the first one,

then half fasten the third, and fourth screws. Finally snug all four screws completely,

following the same order.

Warning! Without a fan or heat sink, the CPU will overheat and cause damage to

both itself and the single board computer. If you are a D SKU user,

please install the CPU cooler (P/N: 1960046526N001) before booting up

the system and do NOT remove any on-board passive heat sinks; if you

are an N SKU user, please do NOT remove any on-board passive heat

sinks.

Improper CPU cooler installation may cause serious CPU die damage;

please follow the instructions above to install your CPU cooler.

PCA-6782 User Manual

Table of Contents