Caller Id - D-Link DVG-6004S User Manual

DVG-6004S/6008S User's Manual

3-5 Caller ID

NOTE: If you register the gateway to a Proxy, you may be unable to make a call because the
gateway will not send the number for authorization.
NOTE: If you register the gateway to a Proxy and you check this option, you may be unable to make a
call. This is due to the fact that the VoIP gateway doesn't send the number for authorization.
D-Link Systems, Inc.
This Manual: http://www.manuallib.com/file/2602385
FXO Caller ID Detection: Used to detect the Caller ID delivered from the PSTN to the FXO port.
When enabled, the Caller ID detected on the FXO port will be sent to the SIP Proxy Server on
transit in (dialing out) calls.
Detection Level: If FXO can't detect Caller ID, try to adjust it until it can.
FSK Caller ID Type: Bellcore is used in Australia caller ID standards.
Anonymous Caller ID (CLIR): When enabled, anyone receiving a call from you will not display
your number if they have caller ID.
CLIR At Transit In W/O Caller ID: When not enabled, if the FXO can detect caller ID in a call
from PSTN, the gateway will use the detected caller ID as caller identification when it makes
transit in calls; if FXO cannot detect caller ID in a call from PSTN, the gateway will use
"anonymous" as caller identification for transit in calls. When it enabled, the gateway will always
uses "anonymous" as caller identification for transit in calls.
Caller ID
19