Do you have a question about the 31704 and is the answer not in the manual?
Questions and answers
Veronica Inman
February 4, 2025
How do I stop clock from flashing All the dates are correct. My model nnumber clock is 317o4 SioScan atomic clock. Please call me 864-233-0510. Please help.
1 comments:
Mr. Anderson
February 10, 2025
To stop the clock from flashing on the SkyScan atomic clock model 31704, follow these steps:
1. Check the Batteries: Ensure that the batteries are fresh and properly installed. Weak or incorrectly placed batteries can cause display issues.
2. Reset the Clock: - Remove the batteries. - Wait for about 10 minutes. - Reinsert the batteries while making sure they are correctly oriented.
3. Set the Time Manually: - If the clock continues flashing, try setting the time manually. - Press and hold the "SET" button until the settings start to flash. - Use the "+" or "-" buttons to adjust the time. - Press "SET" again to confirm each step.
4. Ensure Proper Signal Reception: - Place the clock near a window or away from electronic devices that may interfere with the signal. - The clock may take several hours to synchronize with the atomic signal.
5. Factory Reset: - If the issue persists, perform a complete reset by removing the batteries and pressing the reset button (if available) or holding down the "SET" button for several seconds.
If the clock still flashes after these steps, it may indicate a malfunction.
Need help?
Do you have a question about the 31704 and is the answer not in the manual?
Questions and answers
How do I stop clock from flashing All the dates are correct. My model nnumber clock is 317o4 SioScan atomic clock. Please call me 864-233-0510. Please help.
To stop the clock from flashing on the SkyScan atomic clock model 31704, follow these steps:
1. Check the Batteries: Ensure that the batteries are fresh and properly installed. Weak or incorrectly placed batteries can cause display issues.
2. Reset the Clock:
- Remove the batteries.
- Wait for about 10 minutes.
- Reinsert the batteries while making sure they are correctly oriented.
3. Set the Time Manually:
- If the clock continues flashing, try setting the time manually.
- Press and hold the "SET" button until the settings start to flash.
- Use the "+" or "-" buttons to adjust the time.
- Press "SET" again to confirm each step.
4. Ensure Proper Signal Reception:
- Place the clock near a window or away from electronic devices that may interfere with the signal.
- The clock may take several hours to synchronize with the atomic signal.
5. Factory Reset:
- If the issue persists, perform a complete reset by removing the batteries and pressing the reset button (if available) or holding down the "SET" button for several seconds.
If the clock still flashes after these steps, it may indicate a malfunction.
This answer is automatically generated