Cpu, Chassis, And Power Fan Connectors; Chassis Intrusion Connector - Asus Motherboard P5LD2 Manual

9.

CPU, Chassis, and Power Fan connectors

(4-pin CPU_FAN, 3-pin CHA_FAN1, CHA_FAN2, PWR_FAN)
The fan connectors support cooling fans of 350 mA ~ 2000 mA (24
W max.) or a total of 1 A ~ 3.48 A (41.76 W max.) at +12V. Connect
the fan cables to the fan connectors on the motherboard, making
sure that the black wire of each cable matches the ground pin of the
connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient
air flow inside the system may damage the motherboard components.
These are not jumpers! Do not place jumper caps on the fan connectors!
®
P5LD2 Fan connectors
Only the CPU_FAN connector supports the ASUS Q-Fan feature.
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch cable
to this connector. The chassis intrusion sensor or switch sends a high-
level signal to this connector when a chassis component is removed or
replaced. The signal is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
®
P5LD2 Chassis intrusion connector
ASUS P5LD2
CPU_FAN
PWR_FAN
CPU_FAN
CHA_FAN2
CHA_FAN1
GND
+12V
Rotation
CHA_FAN1
CHASSIS
PWR_FAN
GND
+12V
Rotation
CHA_FAN2
(Default)
2-29