Remote Operation - Uniden DSS 5855 series Owner's Manual

Remote Operation

For your convenience a
remote operation card is
provided for you to use
while away from home
(refer to page 59).
[ 46 ] T H E I N T E G R A T E D A N S W E R I N G D E V I C E
You can operate your answering system from a remote location using any touch-tone
telephone or the handset.
Remote access away from home
You can check, play, or delete messages, even record a new greeting message when you
are away from home. Additionally, you can turn On or Off your answering system from a
remote location.
• Time stamp will not be heard until you have set the time. See "Setting the Time" on page 40.
• You must enter a command within 15 seconds of entering command waiting mode or the answering
system automatically hangs up and returns to standby.
• The system will only playback messages for four minutes and then it returns to command waiting mode.
To continue playing your messages, press
• If you enter an incorrect PIN code three times, you will hear a beep and the system will return to standby.
• During the remote operation, "
1) Call your telephone number.
2) During the greeting message, press
(See "Setting a Personal Security Code", page 40).
3) The answering system announces the current time and the number of messages stored
in memory. You hear "To play incoming messages, press pound two. For help, press
pound zero". You will hear intermittent beeps.
4) You may select a command from the following chart:
Command Function
# 1
then Repeat a Message
# then 2 Playing incoming Messages
# 3
then Skipping a Message
# 4
then Deleting a Message
# then 5 Stop Operation
*For Memo Record and Greeting Message Record function, the first time you enter the
corresponding command, it starts the Recording function. If you want to stop the recording,
press # then 7 or 8.
#
then 2 again within 15 seconds.
" appears on the base.
# and enter your PIN code within 2 seconds.
Command Function
# 6
then Answering System On
# then 7 Memo Record/Stop *
# 8
then Greeting Message Record/Stop *
# 9
then Answer System Off
# then 0 Help Guidance