Traction Pedal Speed Limiter; Parking Brake; Brake Switch - Jacobsen Super LF 1880 Dealer's Manual

5.6

TRACTION PEDAL SPEED LIMITER ___________________________________________

Cutting quality is better at speeds well below the
transport speed of the tractor. An initial mow speed of 6
mph is set at the factory and should be satisfactory for
most cutting conditions. Local turf conditions however
may respond better to a different speed.
To adjust mow speed, loosen jam nut (J) and adjust stop
screw up to reduce speed, or down to increase speed.
Tighten nut to hold adjustment in place.
5.7

PARKING BRAKE__________________________________________________________

Adjust brakes after replacing or servicing brake assembly, or
if pedal travel becomes excessive.
1. When installing new brake pads, burnish pads by driv-
ing tractor at mowing speed while applying a slight pres-
sure on brake pedal for about 5 seconds. Release and
repeat five times before making the final adjustment.
2. Fully loosen adjusting nut (O).
3. Disconnect brake return spring at caliper.
4. By hand, pull cable behind adjusting nut (P) away from
pedal until brake pads just contact brake disk. Thread
adjusting nut (P) up until it contacts the mounting plate.
Tighten nut (O) to lock adjustment in place. Torque nut
(O) to 20 ft lb (27 Nm). Do not overtorque or turn
cable.
5. Connect brake return spring. Repeat for second
cable.
5.8

BRAKE SWITCH ___________________________________________________________

1. Use a volt/ohm meter to determine when switch
contacts open or close.
2. Engage parking brake and adjust brake switch (A)
as required to close contacts. Switch contacts
should open when parking brake is disengaged.
3. Add or remove shims as required to obtain air gap of
3/32 to 1/8 in (2 to 3 mm) is maintained between
sensing surface of switch and brake arm.
Transport Position
J
Start tractor and check operation of brakes. Park tractor
on an incline (approx. 16.7° slope) and engage parking
brake. Brake must prevent tractor from rolling. Adjust nut
(P) as required.
O
U
ADJUSTMENTS
Mow Position
Figure 5E
P
Figure 5F
Figure 5G
5
GB-15