Installation Of The Ms6130 Series Stand - Metrologic MS6130 Installation And User Manual

I
NSTALLATION OF THE
Refer to for numbered components on the previous page
1. Use the stand base (6) as a template to drill and mount the base to the
counter using the mounting screws (9) provided.
2. Feed the wire from the transformer (7) through the slot in the base cover
(5) approximately 9" of the wire.
3. Press the base cover (5) over the base (6).
4. Attach the flex pole (4) to the base (6).
5. Slide the flex cover (3) over the pole (4) and wire.
6. Attach the cradle (1) to the flex pole (4) using the lock washer (10) to
connect the transformer.
7. Insert the transformer plug into the connector inside the stand charger
pack (2).
8. Clip the charger pack to the bottom of the cradle (1) lock in place using
two screws (8).
Stand LED Indicators (with the scanner in the stand)
No LED indicates trickle charge and the green LED indicates fast charge. To
change from trickle charge to fast charge, simply lift the scanner from the
stand and replace.
Note: When both scanner LEDs blink, it is an indication of a
low battery.
MS6130 S
ERIES
S
TAND
21