2
Press or to select Picture Mode.
Picture Settings
Picture Mode
Backlight
Contrast
Brightness
Colour
Tint
Sharpness
Contrast Booster
3
Press or to select your desired Picture
Mode.
NOTE:
The Picture Mode you select aff ects the current input
only. You can select a diff erent Picture Mode for each
input.
Activating the picture preferences
You can customise current Picture Mode settings as
desired. For example, while selecting "Dynamic", if
you change the following items, such as Backlight,
Contrast, Brightness, Colour, Tint, Sharpness, and
the Picture Settings items, your new setting are
saved for "Dynamic" Picture Mode.
1
From the Picture Settings menu, press
or to select either Backlight, Contrast,
Brightness, Colour, Tint or Sharpness.
2
Press or to adjust the settings as desired.
Setting the Contrast Booster
Contrast Booster improves the defi nition of dark
areas of the picture.
1
From the Picture Settings menu, press or
to select Contrast Booster.
Picture Settings
Picture Mode
Backlight
Contrast
Brightness
Colour
Tint
Sharpness
Contrast Booster
2
Press or to select Middle, High, Off or
Low.
506584L9450Series_En.indd 25
506584L9450Series_En.indd 25
Using the TV's features
Standard
70
100
0
0
0
0
Middle
Standard
70
100
0
0
0
0
Middle
Adjusting the Colour Temperature
Colour Temperature increases the warmth or
coolness of the picture by setting the red, green or
blue tint.
1
From the Picture Settings menu, press or
to select Colour Temperature, then press OK.
2
Press or to select Auto, Cool, Natural, or
Warm to suit your preference.
Colour Temperature
Colour Temperature
Red Level
0
Green Level
0
Blue Level
0
Reset
3
Press or to select Red Level, Green Level
or Blue Level, then press or to adjust the
setting as required.
Resetting the Colour Temperature
This function resets your colour temparature
settings to the factory settings.
1
From the Colour Temperature menu, press
or to select Reset, then press OK.
2
A confi rmation message will appear. Press or
to select Yes, and then press OK.
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
1
From the Picture Settings menu, press or
to select Noise Reduction, and then press OK.
Noise Reduction
Auto Clean
MPEG NR
DNR
2
Select Auto Clean, and then press or to
select On or Off .
Off mode :
MPEG NR menu and DNR menu are available.
• MPEG NR mode: Low, Middle, High or Off
• DNR (Digital Noise Reduction) mode: Low,
Middle, High or Off
Cool
On
Auto
Auto
25
2014/08/21 14:23:46
2014/08/21 14:23:46