Toshiba 50L9450 Series Owner's Manual page 21

DTV Manual Tuning
NOTE:
The content of this menu varies depending on the DTV
input that is currently selected.
This feature is available for service engineers or can
be used for direct channel entry if the multiplex
channel is known.
1
From the SETUP menu, press  or  to select
DTV Manual Tuning and press OK.
DTV Manual Tuning
WEAK
Signal Strength
Quality GOOD
Channel
Frequency
Bandwidth
Signal Booster
2
Enter the multiplex number using the Number
buttons or use  or  to adjust the number up
or down.
3
Select Start Scan and press OK.
The television will automatically search for that
multiplex.
DTV Manual Tuning
1 New Channels – Total 6
New Pos.
1
2
7
40
51
When the multiplex is found, any channels
that are not currently in the channel list will be
added and the channel information at the top
of the screen will be updated. ("♦" icon appears
on the New column of the newly added
channels.)
4
Repeat as necessary. Press EXIT to fi nish.
506584L9450Series_En.indd 21 506584L9450Series_En.indd 21
Using the TV's features
AVERAGE STRONG
100%
25
506.0 MHz
8 MHz
On
Start Scan
Name Type
ABC ONE
ABC TWO
ABC THREE
ABC 24
ABCi
DTV Settings
Channels
The channel order may be changed to suit your
personal preference.
1
From the SETUP menu, press  or  to select
DTV Settings and press OK.
2
Select Channels and press OK.
DTV Settings
Channels
Subtitle and Audio
PIN Setting
Parental Control
Local Time Setting
Dynamic Scan
Signal Booster
Over-the-air Upgrade
3
For your convenience, you can jump to specifi c
places in the list by Line Number Jump.
Channels
Line No. 1/10
Pos. Name
1
ABC ONE
2 ABC TWO
7
ABC THREE
40 ABC 24
51 ABCi
822 AA
823 AC
Line Number Jump—Use the Number buttons
(0-9) to input the line number you want to
select and press OK.
Renumber—Press the RED button to renumber
the highlighted channel. Edit the channel
number using the Number buttons and press
OK. If the position number you input already
exists, a confi rmation window will appear.
Move—Press the GREEN button to activate
the Move feature. Press the  or  buttons to
select the channel you wish to move and press
OK to check.
If you wish to move multiple channels at once,
select another channel and check in the same
way. Repeat as necessary.
Once all desired channels have been checked,
press the  or  buttons to place the focus
at the position to which you wish to move the
channels. The channels will be inserted above
the highlighted channel. Press the GREEN
button to execute the move.
03:58
On
On
21
2014/08/21 14:23:45 2014/08/21 14:23:45