Table of Contents
Advertisement
BD-1272 RAIL SAW
Roller Wheel Replacement Continued
9. Position eccentric bushing(s) (A) until the groove on the wheel lines up with the center of the rail
rib. Turn the eccentric bushing(s) (A) until the radial groove of the wheel touches lightly with the
top of the rail rib. Hold the eccentric bushing(s) stationary while tightening down set screw(s) (B)
lightly. Groove aligns with center of upper rail rib. Turn eccentric bushing until wheel groove lightly
contacts upper rail rib. Hold eccentric bushing in place while tightening set screws. DO NOT
FULLY TIGHTEN AT THE TIME.
10. Repeat Steps 7 through 10, if necessary.
11. Tighten all set screws (B).
12. Reinstall the motor and blade guard assembly.
13. Recheck for wheel alignment and smoothness of travel.
B
A
21
MAINTENANCE
B
Advertisement
Table of Contents
