Plunge Cutting For A 90° Cut - BD -1272 Owner's & Parts Manual

BD-1272 RAIL SAW OPERATION
CAUTION
Always use a Grounded Fault Circuit Interrupter (GFCI) with this saw.
Plunge Cutting for a 90˚ Cut
1. Loosen the Tri-Knob (A). Raise the blade to the highest position and move the Saw Assembly to
the beginning of the cut.
2. Adjust the Valve (B) for the desired amount of water flow.
3. Depress motor switch and lower the blade slowly into the material.
4. Tighten the Tri-Knob (A) once the blade cuts through the material. Follow the direction of the cut.
A
B
16