Table of Contents
Advertisement
BD-1272 RAIL SAW
Material Clamps & Alignment
WARNING
Ensure that the electrical cord is not connected before assembling and aligning material clamps.
1. Position Saw Assembly (A) on the slab. The inner side of the blade is approximately 6.25 inches
from the top edge of the aluminum rail.
2. Slide the Material Clamps from both ends of the Rail Assembly until the Clamp Foot (B) is
underneath the slab.
3. Tighten screws (C) until the Saw Assembly is secured to the slab without any side movement.
4. To realign the Rail Assembly, slightly loosen the Material Clamps. Realign the Rail Assembly by
tapping the ends of the Rail Assembly.
5. Repeat Steps 3 and 4 if realignment is necessary.
C
B
A
14
ASSEMBLY
Advertisement
Table of Contents
