Page 1
150W POWER AMPLIFIER Model: APA150 User Manual...
Page 2
Switching to the bridge-mono mode config- ures the APA150 for powering a center channel speaker, or a subwoofer/tactile transducer when used with the on- board low pass filter. Additionally, the full-range line-level outputs allow for daisy chaining amplifiers for a multi-zone whole house audio system.
Page 3
MADE IN CHINA Level Adjustment Auto Turn-On/On Selector Switch Status LED: Line-Level Input Red - Standby/Protection Line-Level Output Blue - Amplifier On Left Speaker Output Power Button Right Speaker Output Low Pass Frequency Adjustment: 50-150 Hz IEC Power Cord Input Low Pass/Flat Selector Switch T3.15AL/T1.6AL 250V Fuses Mono/Stereo Speaker Output Switch...
This warranty gives you specifi c legal rights and you may also have other rights that vary from state to state. Non-Warranty Service: If non-warranty service is required, the product may be sent to the Company for repair/replacement, transportation prepaid, by calling (937) 743-8248 for details, complete instructions, and service fee charges. daytonaudio.com 705 Pleasant Valley Dr. tel + 937.743.8248 Springboro, OH 45066 info@daytonaudio.com...
Need help?
Do you have a question about the APA150 and is the answer not in the manual?
Questions and answers