Page 1
16 Ports Nway Fast Ethernet Switch User’s Manual...
Page 2
FCC Warning This device has been tested and found to comply with limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Table Of Contents Chapter 1 ....................1 Introduction ..................1 Key Features ...................2 Chapter 2 ...................3 Package Contents ................3 Chapter 3 ...................4 Front Panel Layout ...............4 A. 16 RJ-45 10/100Mbps Switch Ports ........4 B. LED Indicators Of 16 Port 10/100Mbps Switch ....4 C.
Chapter 1 16 Ports Nway Fast Ethernet Switch Introduction The Switch provides 16 10/100Mbps ports. It was designed for easy installation and high performance in an environment where traffic on the network and the number of user increasing continuously. The 19-inch standard rack-mount size was specifically designed for ROBO (Remote Office &...
Key Features 16 Ports 10/100Base-T/TX Auto-negotiation and Auto-MDIX Switch. Built-in storage of 8K MAC addresses. 19-inch Rack-mount size 1 U high design. Support Auto MDIX crossover capabilities. Broadcast storm control Store & Forward switching methods Flow control fully supported: Half-duplex mode back-pressure flow control.
Chapter 2 Package Contents Before you start to install the Switch, please verify your package that contains the following items: One Fast Ethernet Switch Rack-mount Kit For Rack Installation One Power Cord One User’s Manual Note: If any of these items is found missing or damaged, please contact your local supplier for replacement.
Chapter 3 Front Panel Layout A. 16 RJ-45 10/100Mbps Switch Ports There are 1~16 RJ-45 connectors on the front panel for connecting to servers, workstation or other network devices. The Switch provides 16 10/100Mbps switching ports that could sense the 10/100M speed and negotiate Full/Half-duplex mode automatically.
Rear Panel Layout A AC input. AC input (90-260V/AC, 50-60Hz) UL Safety. Chapter 4 Rack Mounting Optional Rack-mounting brackets are available to mount Switch in standard EIA 19-inch rack. 16 port 10/100Mbps Switch is supplied with two mounting brackets and eight screws. And please assemble according to the following steps.
Chapter 5 Installation Note: The Switch supports the AUTO-MDIX function. Just make sure the twisted-pair cables meet the ANSI/EIA/TIA 568A(straight-through) or 568B(crossover) specification. A. How to connect the Switch to PCs, servers, and other network devices Connect straight-through twisted-pair cable (Cat. 5) to the Switch and PCs, servers and other network devices.
B. How to UP-Link the Switch to a Switch or a Hub Use CAT5 twisted pair cable to connect the Switch to another Switch or Hub on any port. Don’t worry about to use straight-through cable or crossover cable. The switch support AUTO-MDIX on all port. Chapter 6 - - 7...
Appendix A. ANSI/TIA/EIA-568-A PLUG & Twisted-pair Cable The IEE802.3u Standards permits the use of category 3, 4, 5 or better balanced cable pairs, installed according to ANSI/EIA-568-A. This appendix provides pinout and brief information for the CAT5 unshielded twisted pair cables B.
Need help?
Do you have a question about the LBS216AE-R3 and is the answer not in the manual?
Questions and answers