Microwave Leakage Test; Burn In; Serial Number Edit; Self Test - TurboChef ENCORE Service Manual

Microwave leakage Test

While in Manufacturing Mode (page 20), select
"MW Leak Test" to begin a microwave leakage test.
The oven will warm up to 500°F (260°C). When
warmup is complete, insert the water load and
follow the steps on page 26.
MANU FAC TURING MODE
MW LEAK TEST
MW PWR TEST

BURN IN

SERIAL NO. EDIT
PSM tH1H2AW
Figure 27: Microwave leakage Test
Microwave Power Test
Do not use - for manufacturer use only.
burn In
While in Manufacturing Mode (page 20), select
"burn In" to begin a 25-minute burn in. This
feature helps ensure the reliability of test results by
adequately warming the cavity walls. burn in is not
usually required unless instructed by TurboChef.
MANU FAC TURING MODE
MW LEAK TEST
MW PWR TEST
BURN IN
SERIAL NO. EDIT
PSM tH1H2AW
Figure 28: burn In

Serial Number Edit

While in Manufacturing Mode (page 20), select
"Serial No. Edit" to edit the serial number (may be
required when replacing a control board).
MANU FAC TURING MODE
MW LEAK TEST
MW PWR TEST
BURN IN
SERIAL NO. EDIT
PSM tH1H2AW
Figure 29: Select "Serial Edit"

SELF TEST

VOLT ON
ERASE/DEFAULT
FAHRENHEIT 355F
CC = 73F / 76F
SELF TEST
VOLT ON
ERASE/DEFAULT
FAHRENHEIT 355F
CC = 73F / 76F
SELF TEST
VOLT ON
ERASE/DEFAULT
FAHRENHEIT 355F
CC = 73F / 76F
To edit the serial number (Figure 30):
- use the number/letter keys to change a
character. After one second, the cursor will
advance to the next character.
- Select "<" to move the cursor back.
- Select ">" to move the cursor forward.
- Select "Save" to save your changes or "Cancel"
to exit without saving.
SERIAL NUMBER EDIT:
< S/N = ENCD01145
C ANCEL
Figure 30: Serial Number Edit Screen
Self Test
While in Manufacturing Mode (page 20), select
"Self Test" to access the oven self test screen.
MANU FAC TURING MODE
MW LEAK TEST
MW PWR TEST
BURN IN
SERIAL NO. EDIT
PSM tH1H2AW
Figure 31: Select "Self Test"
From the Self Test screen (Figure 32):
- "Auto Test" will run all tests (listed below).
- "Door Test" will test the door switch sequence.
- "blower Test" will increment the blower motor
speed to verify response at each setting.
- "Mag Test" will test magnetron operation.
- "Heater Test" will test heater operation.
When each test completes, the oven will display
PASS or FAIL.
SELF TEST
AUTO TEST
DOOR TEST
BLOWER TEST
MAG TEST
PSM tH1H2AW
Figure 32: Self Test Screen
>
SAVE
SELF TEST
VOLT ON
ERASE/DEFAULT
FAHRENHEIT 355F
CC = 73F / 76F
HEATER TEST
CC = 73F / 76F
21