Access From The Base; Anti-Flooding Device (If Featured); Adjustable Rear Foot (Built-In Versions Only); Sump Assembly - Electrolux DIVA Series Service Manual

Access from the base

6
NB: Before laying the dishwasher on a side panel or on the rear panel remove the water
in the sump by suction, for example with a syringe, so as it does not reach the pressure

6.1 Anti-flooding device (if featured)

(a) Remove the bottom panel (if featured) (see 1.3).
(b) Lift up and release the anchor tab.
(c) To replace the microswitch, lever the tabs open and remove.

6.2 Adjustable rear foot (built-in versions only)

(a) Remove any residual water from the sump by suction
so that it does not flow into the tub and the pressure
switch tubes, then lay the appliance on the rear panel.
(b) Remove the regulation screw from the bottom panel
(see 1.3b).
(c) Using a tool, detach the foot support and slide away
from the base.

6.3 Sump assembly

(a) Remove any residual water from the sump by suction so that it does not flow into the tub and the
pressure switch tubes when the appliance is laid on the rear panel.
(b) Remove the plinth (free-standing versions) and the foot support
(see 1.2).
(c) From inside the tub, remove the basket and the lower spray
arm (see 3.3).
(d) Remove the central drain filter (see 3.1) and the large washing
filter (see 3.2).
(e) Remove the two screws which secure the spray arm support
column and remove the column.
(f) Remove the two screws which secure the tub to the sump.
(g) Remove the bottom panel (if featured) (see 1.3).
(h) Remove the anti-flooding device (if featured) (see 6.1).
(j) Remove the thermostat and the O-ring (see 5.8).
SOI/TD
switch tubes or the tub.
(i) Detach all the hoses (to the
heating element,
softener, the washing motor, the
drain pump and the pressure
switches).
( i )
15/23
(k)
the water
(b)
(e),(f )
599 37 44-27