Supports For Upper Basket Wheels; Lateral Uprights; Hinges And Hinge Springs - Electrolux DIVA Series Service Manual

7.2 Supports for upper basket wheels

(a) Remove the worktop (see 1.1), the plinth and the foot support
(see 1.2), the appropriate lateral panel (see 1.4) and the upper
basket (see 3.4.a).
(b) From outside the tub, remove the two screws which secure
the basket guide wheels in position.

7.3 Lateral uprights

(a) Remove the worktop (see 1.1), the plinth (free-standing versions)
and the foot support (see 1.2), the lower front cross-member (see
7.13) and the appropriate lateral panel (see 1.4).
(b) Open the door and block in position (see 5.5.b).
(c) Remove the three lateral screws from inside the tub.
(d) From the inside of the tub, remove the four screws which secure the
upper front cross-member in position.
(e) Remove the four screws which secure the cross-member at the front (see 7.13.b)
(f) Remove the two screws which secure the hinge to the inner
door (see 5.5.d)
(g) Detach the earth wire and the hinge strut (see 7.4.e).
(h) Remove the three lower frontal screws which secure the
upright to the base.
(i) Remove the four plastic clip rivets: use a tool to push the central stud of the
rivet from the exterior towards the interior of the tub and remove the assembly
(when refitting, replace the rivet if damaged).
(j) Slide the upper cross-member off the upright.
(k) Remove the cross-member from its seat in the base.

7.4 Hinges and hinge springs

Proceed as follows to replace each hinge:
(a) Remove the external door (see 5.3), the worktop (see 1.1), the plinth (free-
standing versions) and the foot support (see 1.2) and the appropriate lateral
panel (see 1.4).
(b) Use a piece of wire or string to detach the tensioner spring from its
seat on the upright.
(c) Remove the two screws which secure the hinge to the inner door
(see 5.5.d)
(d) Remove the screw which secures the hinge to the upright.
(e) Pull and detach the hinge pin and the earth wire.
When replacing:
Fit the spring to the hinge; then, using a piece of string and a pair of pliers,
attach it to the hook on the upright.
SOI/TD 18/23
(c)
(d)
(i )
(b)
599 37 44-27