Maintenance; Changing The Abrasive Wheel - Delta 20-142C Instruction Manual

MAINTENANCE

Changing The Abrasive Wheel

DISCONNECT TOOL FROM POWER SOURCE
Figure 18
Rotate the front wheel guard (A) to the up
position.
Figure 19
Press arbor lock (A) toward wheel housing while
rotating wheel (B) by hand until the arbor lock
engages.
Figure 20
Using the supplied wrench, loosen arbor screw
(A) by turning it counterclockwise. Remove
arbor screw, washer (B), outside wheel flange
(C), and wheel (D).
NOTE: Do not remove inside wheel flange.
Clean the inside surfaces of both the inside and
outside wheel flanges.
Install new wheel and replace outside wheel
flange, washer, and arbor screw. Tighten arbor
screw clockwise.
IMPORTANT: Use only reinforced abrasive
wheels with blotters and tighten arbor screw
only enough to hold wheel firmly and prevent
slippage. Excessive tightening may result in
damage.
Rotate front wheel guard to down position and
disengage spindle lock before starting tool.
11
Fig. 18
Fig. 19
Fig. 20