Troubleshooting - Magnum MEC46 Product Instruction Manual

TROUBLESHOOTING

Problem
The machine doesn't bind/punch
Punched holes are not central
Machine will not punch
Punch holes are not parallel to
edge
Partial holes
Damaged hole edges
Clause
Machine is not switched on
Edge guide not set
Blockage
Debris is stuck below dies
Sheets not correctly aligned to punch
pattern
Possibly overloading the machine
5
Solution
Switch on machine at rear
Adjust edge guide until hole pattern is correct
Check waste tray is empty. Check for blockage
to paperentry
Take stiff cardboard and slide into the paper
entry. Move the cardboard sideways to release
any stray clippings into the waste tray
Adjust edge guide and test punch scrap sheets
until correct
Punch plastic covers with paper sheets.
Reduce number of sheets being punched