Safety; Regulations; General Notes On Safety - Pfaff 1525 Instruction Manual

Safety

1 Safety
1

Regulations

.01
The machine has been constructed in accordance with the requirements listed in the
EC Declaration of Conformity and the Declaration of Incorporation.
In addition to this instruction manual, please also observe all generally accepted, statutory
and other legal requirements, including those of the user's country, and the applicable pol-
lution control regulations!
The valid regulations of the regional social insurance society for occupational accidents or
other supervisory authorities are to be strictly adhered to!
1

General notes on safety

.02
● The machine must only be operated by adequately trained operators and only when the
● All notices on safety and the instruction manual of the motor manufacturer are to be read
● All notes on the machine concerning danger and safety must be observed!
● The machine must be used for the purpose for which it is intended and must not be
● When part sets are changed (e.g. needle, presser foot, needle plate, feed dog or bob-bin),
● Daily maintenance work must only be carried out by appropriately trained persons!
● Repairs and special maintenance work must only be carried out by qualified technical
● During maintenance or repairs on the pneumatic system the machine must be isolated
● Work on the electrical equipment must only be carried out by technical staff who are
● Work on parts or equipment connected to the power supply is not permitted! The only
● Conversion or modification of the machine must only be carried out under observation of
1 - 1
instruction manual has been fully read and understood!
before the machine is put into operation!
operated without its safety devices; all regulations relevant to safety must be adhered to.
during threading, when the workplace is left unattended and during maintenance work,
the machine must be isolated from the power supply by turning off the on/off switch or
removing the plug from the mains!
staff or persons with appropriate training!
from the compressed air supply! The only exception to this is when adjustments or
function checks are carried out by appropriately trained technical staff!
qualified to do so!
exceptions to this are specified in regulations EN 50110.
all relevant safety regulations!