Setting Up The Machine; Setup And Transporting Precautions - Brother 882-T51 Operation Manual

Setting Up the Machine

The procedures for setting up the machine are described below. If the machine is not set up correctly, it
may shake or produce loud noises and the embroidery will not be sewn correctly. An optional
embroidery stand is also available.

Setup and transporting precautions

• The temperature of the operating environment should be between 5 °C and 40 °C. If the machine is
operated in an environment that is either too cold or too hot, the machine may malfunction.
• Do not use the machine in a location where it will be exposed to direct sunlight, otherwise the machine
may malfunction.
• Set up the machine with it's four adjustable feet completely in contact with the desk or table, so that the
machine is level.
• The machine weight is approximately 31 kg. The transporting or setting up of the embroidery machine
should be performed by two people.
• When transporting the machine, be sure to lift it from the bottom at the indicated positions by two
people. Lifting the machine from any other area may damage the machine or result in the machine falling,
which could cause injuries.
• When lightning occurs, turn off the machine and unplug the power supply cord. Lightning may cause the
machine to malfunction.
• Do not plug in the power supply cord until setup of the machine is completed, otherwise injuries may
result if the "Start/Stop" button is accidentally pressed and the machine starts sewing.
• When lubricating the machine, wear protective eyeglasses and gloves to prevent the oil or grease from
getting into your eyes or on your skin. Do not put the oil or grease into your mouth. Keep the oil and
grease out of the reach of children.
10
CAUTION