Disassembling the starter motor
1. Clean the starter motor externally.
2. Remove the solenoid.
3. Remove the protective cover from the rear bearing
casing. Remove the locking ring and where fitted,
the shim(s).
4. Remove the rear bearing casing.
5. Remove the brush plate. Remove the stator hous-
ing from the gear housing.
6. Remove the lever arm that is fitted in the gear
housing and the rotor.
7. Remove the starter gear that is fitted in the gear
housing. First remove the locking ring by striking
the contact ring with a suitable sleeve.
Group 30 Electrical system
87