Table of Contents
Advertisement
The display D d shows which preset button
is pressed.
Follow these steps if you want to store further
stations of all wavebands on the other preset
buttons and memory banks.
If the automatic search tuning stops on a
frequency which was already stored before,
then the corresponding preset button will be
indicated for about 5 seconds in the display
D d together with the memory bank D c,
but the latter only if it is an FM station.
... using Travelstore
The Travelstore function automatically sto-
res the six strongest FM radio stations of your
area and sorts them according to their field
strength. This function is helpful, above all,
on long-distance travels.
To memorize these stations with Travelstore
press the FM•T button C for about 2
seconds.
The radio reproduction is muted until the six
strongest stations are stored.
If required, stations can also be stored man-
ually on the Travelstore bank. The display
shows dashes to indicate the free preset
buttons.
... using manual tuning
If you want to manually tune in and store a
station, use the rocker switch << >> G to
enter the frequency.
Use the FM•T C or AM A button to
select the waveband.
If you wish to store an FM frequency,
use the FM•T button C to select the
memory bank.
Adjust the frequency with the rocker
switch << >> G.
Store the frequency by
pressing the preset buttons (until the
set resumes play).
In addition to the stored station frequencies,
the stations tuned in last on each waveband
remain stored.
The mono switching
Your car radio is fitted with a Blaupunkt FM
tuner (Codem III) which provides for mostly
undisturbed reception on the road.
In areas with poor reception conditions or
multipath interferences due to signal echoes,
the radio set switches gradually between
stereo and mono. This considerably impro-
ves the on-the-road reception quality.
To avoid stereo noise common in very critical
reception areas, we recommend to switch to
mono.
To switch between stereo
press lo 6 for more than 2 seconds.
In mono mode, the stereo indicator
goes off.
Adjusting the search tuning
sensitivity
a) with dx and lo 6.
The adjustment is shown in the display
D e and D g.
lo - Normal search tuning sensitivity
(local)
dx - High search tuning sensitivity (di-
stant)
b) via software with DSC
When the station density is extremely
high or low, it can be useful to separa-
tely adjust the level of the two sensitivi-
ties. For this,
press the DSC button 5.
Press the rocker switch
until "DIS" (sensitivity level dx) or
"LOCAL" (sensitivity level lo) and a
number between 1 and 3 are shown
in the display D a. Use the dx and
lo button 6 to switch between LO-
CAL and DIS.
mono
D f
F
/
23
Advertisement
Table of Contents
