Supporting The Motorcycle - Yamaha 2015 YZF-R3A Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
3
1. Bolt
2. Screw
3. Rear fender lower panel
6
3. Remove the license plate light
bulb socket (together with the
bulb) by pulling it out.
4. Remove the burnt-out bulb by
pulling it out.
2
1
1. License plate light bulb
2. License plate light bulb socket
5. Insert a new bulb into the socket.
6. Install the socket (together with
the bulb) by pushing it in.
1
7. Install the rear fender lower panel
2
by installing the bolts and screws.
8. Install the mudguard by installing
the quick fasteners.
2

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
2. Raise the front wheel off the
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
6-35
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
ground by using a motorcycle
stand.
EAU24351