Thermostat Installation; Normal Sequence Of Operation - UTICA BOILERS STARFIRE 3 STEAM Installation Manual And Operating Instructions

1. Thermostat should be installed on an inside wall about four feet above the floor.
2. NEVER install a thermostat on an outside wall.
3. Do not install a thermostat where it will be affected by:
A. Drafts
B. Hot or cold pipes
C. Sun light
D. Lighting fixtures
E. Television
F. Fireplace or chimneys
4. Check thermostat operation by raising and lowering thermostat as required to start
and stop the burner.
5. Instructions for the final adjustment of the thermostat are packaged with the
thermostat ( adjusting heating anticipator, calibration, etc.).
NORMAL SEQ NORMAL SEQ
NORMAL SEQUENCE OF OPERA NORMAL SEQ NORMAL SEQ
On a call for heat, the thermostat will actuate, completing the circuit to the boiler.
In turn, the ignition systems are activated and ignition will begin.
In the event of a low water condition, an automatic low water cut-off device will
interrupted power between the low water cut-off and the burner. The burner will remain off
until the low water condition is corrected, (i.e., manually restore boiler water or utilize a water
feeder device which will automatically restore water to its normal operating level).
IMPORTANT TO THE INSTALLER: Before putting the boiler in operation, test the
Mechanical low water cut-off device for proper operation. While burner is on, open the blow-
off valve located in the lower portion of the cut-off body. This will drain the water quickly from
the cut-off body and break the circuit to the burner. If it does not, replace control.
W W W W W ARNING: ARNING: ARNING:
ARNING: ARNING:
Refill boiler to its normal water line.
THERMOSTA A A A A T INST THERMOST THERMOST
THERMOST THERMOST
UENCE OF OPERA UENCE OF OPERA
UENCE OF OPERATION UENCE OF OPERA
WATER WILL BE BOILING HOT.
T INSTALLA T INST T INST ALLATION ALLA ALLA
T INST ALLA
PAGE 11
TION TION TION
TION
TION TION
TION TION