Installing The Quick-Release Levers; Attaching The Wheels - Burley d’Lite Owner's Instruction & Safety Manual

III.

Installing the Quick-Release Levers

In the bag with the reflectors you'll find two quick-release levers.
Install these through the hollow axle of the wheel. Make sure the
lever is on the flat side of the wheel, the thumb nut is on the deep-
dished side, and the springs are mounted on each side as shown in
the illustration below.
Deep Dish
The quick-release lever
must be on flat side of
wheel and thumb nut on
deep-dished side. This
ensures that the lever
will be on the outside
when wheel is properly
installed.
IV.

Attaching the Wheels

First, verify that the tires are inflated to 30–35 P.S.I. Next, tip the
trailer frame on its back end. If you are working on a rough or dirty
surface, lay down a cloth or other protective barrier to avoid damage
to your trailer. Move the quick-release lever to the unlocked position
and place the wheels into the dropouts, making certain that the
axles go all the way into the slots.
The quick-
release lever
and flat side of
wheel must be
installed toward
outside of trailer.
Correct
4
Flat
Thumb Nut
Wrong
XII. Safety Checklists
Before Each Ride, Ensure the Following:
√ Wheels tightly attached
√ Tire pressure 30–35 P.S.I.
√ Hitch properly secured with safety strap in place
√ Locked safety pins for tongue and roll bar
√ Maximum load 100 lbs.
√ Bicycle safety check, especially brakes and tires
√ Helmets for children & rider
√ Safety flag in place
√ Both seat buckles in rear of seat are securely fastened
Quick
Release
Monthly Checklist
Lever
√ Inspect tongue and hitch for damage, scratches, or loose fasteners
√ Inspect tongue pivot for smooth operation: tongue should fold and
unfold freely; lubricate brass bushing if necessary
√ Inspect frame tubing and hardware for cracks, damage, or loose parts
√ Inspect tires; worn out or cracked tires can lead to blowout
√ Inspect wheels for trueness and cracks
√ Inspect wheel bearings for wear
√ Inspect fabric canopy, child seat, and harness for rips, abrasion, or
missing/damaged hardware
√ Contact authorized Burley dealer for repairs/replacement of
damaged or worn out parts
IMPORTANT: Refer to section "X. Trailer Maintenance and Care" of this
manual for additional periodic maintenance. Unless you are a qualified
bicycle mechanic, contact your Burley dealer for repairs and maintenance.
any
21