Adjust The Position Of The Rear Edge Paper Guide - Sharp SF-2030 Service Manual

19. Adjust the position of the rear edge paper
guide.
Loosen the two screws which secure the rear edge paper guide until
it becomes possible to move the paper guide.
Next, fit the rear edge paper guide into the appropriate position cor-
responding to the desired paper size, and then also secure the two
mounting screws into the holes corresponding to the desired paper
size.
20. Set the paper size detection spacer.
Change the position of the paper size detection spacer to the position
corresponding to the desired paper size.
Paper size
detection spacer
(Example: Position for A3 size paper)
Paper size detection spacer position diagrams
AB system
A4
A4R
B4
B5
B5R
EXTRA
Inch system
8 1/2 x 14
8 1/2 x 11
8 1/2 x 11R
EXTRA
Rear edge paper guide
21. Change the paper size indicator.
Remove the paper size indicator and re-insert it so that the paper size
for which the cassette has been set is visible in the paper size indica-
tion window.
Note that paper size indications are printed on both sides of the paper
size indicator.
Paper size indicator
22. Re-insert the large-capacity paper cassette.
Lift up on the handle of the large-capacity paper cassette and re-in-
sert in as far as the paper loading position.
23. Place the paper in the cassette.
Place the paper in the paper cassette.
When doing this, do not stack the paper higher than the maximum
height line indicated on the cassette.
Next, push the cassette all the way into the desk as far as it will go.
5 – 34
Maximum height line