Locking Clip - Honda 1994 Accord Wagon Reference Owner's Manual

Child Safety
Using a Seat Belt

Locking Clip

Always use a seat belt locking clip
when you secure a child seat to
your car with a lap/shoulder belt.
This helps prevent the seat from
shifting position or overturning.
A locking clip is usually included
with the child seat. If you need a
clip, contact the seat's
manufacturer or a store that sells
child restraints.
To install a locking clip, do the
following:
1. Place the child restraint in the
desired position. Route the
lap/shoulder belt through the
restraint according to the seat
manufacturer's instructions.
2. Insert the latch plate into the
buckle. Pull on the shoulder
part of the belt to make sure
there is no slack in the lap
portion.
Driver and Passenger Safety
3. Tightly grasp the belt near the
latch plate. Pinch both parts
of the belt together so they
won't slip through the latch
plate. Unbuckle the seat belt.
4. Install the locking clip as
shown. Position the clip as
close as possible to the
latch plate.
5. Insert the latch plate into the
buckle. Push and pull on the
child seat to verify that it is
held firmly in place. If it is not,
repeat these steps until the
restraint is secure.
Using Child Restraints
With Tethers
TETHER
ATTACHMENT
POINTS
Your Honda has three attachment
points for tether-style child seats.
Two are on the floor behind each
rear seat. A third attachment point
is at the headliner at the tailgate
opening. To access, remove the
plug cap.