Honda 1994 Accord Wagon Reference Owner's Manual page 160

6. Reinstall the bulb holder
assembly by lining up the
bulbs with their holes in the
lens assembly; then, turn the
assembly one-quarter turn
clockwise to lock it in place.
7. Test the lights to make sure
the new bulb is working.
8. When reinstalling the taillight
assembly, align and pop the
snap fasteners in place. Install
and then tighten the screws.
Lock the tabs in place.
Replacing a High-Mount
Brake Light Bulb
Push.
1. Open the tailgate. Undo the two
fasteners on the side of the cov-
er by pushing on the center of
each fastener's head until the
center pops in.
2. Use a thin, flat blade to wedge
the fastener's head out. When
both fasteners are out, remove
the high-mount brake light
cover.
3. Remove the socket by turning it
one-quarter turn counterclock-
wise.
4. Pull the bulb out of its socket.
Push the new bulb into the
socket.
5. Test the brake light to make
sure the new bulb is working.
6. Reinstall the cover.
7. Reset the center section of the
fastener through the fasten-
er's head. Make sure the fin-
gers on the fastener are folded
and flush to the fastener, and
that the center section pro-
trudes beyond the head.
8. Install each reset fastener into
the cover. Secure each
fastener by pushing on the
center until it locks (the
center is flush with the head).
Maintenance
Lights