Yamaha X-Max YP125RA Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
Oil Trip and V-Belt Trip display total
distance traveled from the first run or
when the last reset was done.
To reset a tripmeter, select it by push-
ing the "TRIP" button until "Trip, Trip
Time, F Trip" is displayed. While "Trip,
3
Trip Time, F Trip" is displayed, push
the "TRIP" button for 3 seconds. If you
do not reset the fuel reserve tripmeter
manually, it will reset itself automatical-
ly and the display will return to the prior
mode after refueling and traveling 5 km
(3 mi).
TIP
The display cannot be changed back
to "F Trip" after it has been reset.
Oil change indicator "Oil"
This indicator flashes at the initial 1000
km (600 mi), then at 5000 km (3000 mi)
and every 6000 km (3500 mi) thereafter
to indicate that the engine oil should be
changed.
After changing the engine oil, reset the
oil change indicator.
To reset the oil change indicator
1. Turn the key to "ON".
2. Push the "TRIP" button until "Oil"
(oil change tripmeter) is displayed
in the odometer and trip meter
display. While "Oil" is displayed,
push the "RESET" button for at
least 3 seconds. The oil change
tripmeter value will flash.
SELECT RESET
2
1
TRIP
INFO
ZAUM1121
1. "TRIP/INFO" switch
2. "RESET" button
3. Hold the "RESET" button pushed
for 15 to 20 seconds.
3-8
SELECT RESET
1
ZAUM1122
1. "RESET" button
4. Release the "RESET" button, and
the oil trip value will reset to zero.
TIP
If the engine oil is changed before the
oil change indicator comes on (i.e. be-
fore the periodic oil change interval has
been reached), the indicator must be
reset after the oil change for the next
periodic oil change to be indicated at
the correct time. To reset the oil
change indicator before the periodic oil
change interval has been reached, fol-
low the above procedure.
The electrical circuit of the indicator
can be checked according to the fol-
lowing procedure.
1. Turn the key to "ON".