Equipment Required - Ericsson MDX SERIES Installation Manual

EQUIPMENT REQUIRED

The equipment required for installing the MDX Mobile Radio is listed
below:
•
Electric drill for drilling mounting holes.
•
Drills and circle cutters as follows:
•
No. 31 (1/8-inch) drill for No. 8 self-tapping screws.
•
No. 27 (9/64-inch) drill for No. 10 self-tapping screws.
•
5/8-inch drill or circle cutter for power cable.
•
3/4-inch circle cutter, hole saw or socket punch for antenna (op-
tional).
•
Phillips and flat-blade screwdrivers, and 1/4-inch and 5/16-inch hex-
head drivers for mounting screws.
•
No. 15 Torx® driver (ST0606).
•
No. 15 Torx® tamper-proof driver (ST0618) if latch security screw
(supplied in hardware kit) is used.
•
No. 25 Torx® driver (STO610).
•
POZIDRIV® driver for mounting screws.
Torx® isa registered trademark of CAMCAR Division TEXTRON. Inc.
POZIDRIV® is a registered trademark of Phillips International company.
Be careful to avoid damaging some vital part (fuel tank, transmission
housing, etc.) of the vehicle when drilling mounting holes. Always check
to see how far the mounting screws will extend below the mounting
surface before installing.
If pilot holes must be drilled, remove all metal shavings from drilling holes
before installing screws.
Radio installations in vehicles powered by liquefied petroleum gas must
conform to the following requirements.
8
CAUTION
CAUTION
WARNING