Equipment Required; Installations In Vehicles Powered By Liquefied (Lp) Gas - Ericsson LBI-38610A FMD Installation Manual

Table of Contents

It is suggested that you take advantage of the experience of one of the

many authorized Service Stations located throughout the United States by

having them install your radio and make the final adjustments. A typical in-

stallation is shown in Figure 2.

Interference with vehicular electronics - Electronic fuel injection

systems, electronic anti-skid braking systems, electronic cruise con-

trol systems, etc. are typical of the types of electronic devices which

may be prone to malfunction due to the lack of protection from ra-

dio frequency energy present when transmitting. If the vehicle con-

tains such equipment, consult the dealer for the make of vehicle for

help in determining if such electronic circuits will perform nor-

mally when the radio is transmitting.

EQUIPMENT REQUIRED

The equipment required for installing the radio and accessories is listed

below:

• Electric drill for drilling mounting holes

• Drills (see sizes in box)

• Phillips screwdriver and Allen wrench for mounting screws

• Electrical Tape

• No. 36 (7/64-inch) drill for No. 6 self-tapping screw

• No. 31(1/8-inch) drill for No. 8 self-tapping screws

• No. 27 (9/64-inch) drill for No. 10 self-tapping screws

• No. 9 (3/16-inch) drill for No. 9 self-tapping screws

Radio installation in vehicles powered by liquefied petroleum gas

must conform to the following requirements.

WARNING

DRILL SIZES

WARNING

Table of Contents