Table of Contents
Advertisement
AUTOMATIC OPERATION
The device will automatically determine the operation mode of COOL, or DEHUMIDIFY
depending on the initial room temperature. The selected mode of operation will not change
when the room temperature varies.
Press the FUNCTION selector so that the display indicates the
O (AUTO) mode of operation.
•
When AUTO is selected, the device will automatically
determine the mode of operation COOL or DEHUMIDIFY
depending on the current room temperature.
•
The FAN SPEED selector does not work at this time: the
FAN SPEED is AUTO during COOL and LOW during
DEHUMIDIFY.
Press the ® (START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
As the settings are stored in memory in the remote controller, you
only have to press the ® (START/STOP) button next time.
Press the TEMPERATURE button and the
temperature setting will change by 1 °C each time.
The preset temperature and the actual room temperature may
vary somewhat depending on environmental conditions.
The display does not indicate the preset temperature in the AUTO
mode. If you change the setting, the cooling unit will produce a
beep.
You can raise or lower the temperature setting as necessary by
maximum of 3°C.
°c
■ Condition of Automatic Operation
Initial room temperature
(approx.)
Function
Temperature setting
FAN SPEED
Over 27°C
■ ►
COOL
27°C
HI at start, MED or LOW
after the preset temperature
is reached
Below 27°C
■ ►
DEHUMIDIFY
Slightly lower than the
room temperature
LOW
-
5
-
Advertisement
Table of Contents
