4.5.2 Method of restraint
The MVP502 was tested with four point webbing systems, with the back in the
upright position. Please refer to the restraint manufacturer's user guide for further
details of its operation.
Fitting the front restraint
Connect the straps around the wheelchair frame and caster bracket as pictured below. The anchor point is marked with a yellow
sticker.
Take the brakes off and reverse the wheelchair to tension the front straps. Apply wheelchair brakes (the brakes should be left on
during transport)
Fitting the rear restraint
Attach rear straps into rail approximately 11.81 in. behind the wheelchair backrest.
Attached the hooks to the wheelchair brackets at the rear of the wheelchair as pictured below. Tension the restraint until the
wheelchair is secure.
20