How To Operate - Malmbergs MFD20-522R2 Instruction Manual

Emptying the water tank
1. Remove water tank from the dehumidifier.
2. Hold the tank by the handle and carry it gently.
3. Tilt the tank to the direction as shown and slowly
empty out the water of the tank.
4. Replace the tank in the dehumidifier.
After the dehumidifying operation, water is col-
lected in the water tank. When the tank is full
of water, the dehumidifier stops operating auto-
matically and the buzzer sounds.
The buzzer sounds for 10 seconds when the tank
is taken out during the operation.
For continuous draining, see the page 40.

HOW TO OPERATE

• Your dehumidifier will stop automatically after the hours set by the timer (0H to 12H)
• In any mode, you can press "TIMER" switch to set the timer 0H to 12H
Plug in the dehumidifier to an outlet.
• "Automatic"mode lamp will flash.
• Make sure that the water tank is installed properly.
• Adjust the air outlet flap to achieve desired air direction.
Press the switch
• "Automatic"mode lamp will light up.
36
Note
Handle
Continuous
Automatic