FCC Information This equipment has been tested and found to comply with limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec- tion against harmful interference in a residential installation. This equipment can generates, uses, and radiate radio fre- quency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio...
Safety Information Provided with this monitor is a detachable power supply cord with IEC320 style terminations. It may be suitable for con- nection to any UL listed personal computer with similar con- figuration. Before making the connection, ensure that the voltage rating of the computer convenience outlet is the same as the monitor and that the ampere rating of the computer convenience outlet is equal to or exceeds the monitor current...
Installation No tools are required to install the EO710f. Simply follow the instructions outlined in the next few pages. Connect Power Cord Connect the female end of the power cable to the power input receptacle on the back panel of the EO710f. Then, plug the male end of the power cable into an AC outlet.
Controls & Functions Base of Unit Assemble the tilt/swivel base onto the bottom of the monitor. Turn the monitor for a comfortable viewing angle within 80 degrees horizontally and 20 degrees vertically. Signal Cable (VGA Cable) Connect the end of the signal cable to your graphics card on your computer.
Page 8
Controls & Functions The OSD menu activates when you press the “MENU” button. Use either the “Up” button to move your selection up or “Down” button to move your selection down. After making your selection, Press the “Enter” button and you will be able to move your selection in the sub-menu to the right.
Page 9
Controls & Functions Pincushion (Side-Pin) Select this function, then use the “UP/DOWN” buttons to straighten the sides of the image by pulling them in opposing directions. Pin Balance Select this function, then use the “UP/DOWN” buttons to straighten the sides of the image by pulling them in the coressponding direction.
Page 10
Controls & Functions English Selecting this will change your OSD to English. Deutsch Selecting this will change your OSD to German. Francais Selecting this will change your OSD to French. Espanol Selecting this will change your OSD to Spanish. Italic Selecting this will change your OSD to Italian.
Troubleshooting The monitor is switched ON, but the Power LED indicator is not lit and there is no display on the screen. Check all the power connections and make sure they are secure. If the monitor is plugged into a surge protector, make sure that the surge protector is switched on.
Page 14
Troubleshooting How do I change the frequency or refresh rate the monitor uses? The refresh rate is controlled by the video card. In your “Display Properties,” press the “Advanced” button. Select the Adapters tab. There should be a list of refresh rates. Why do the characters in the corner of the screen look fuzzier than the center? One of the limitations of a CRT screen is that the focus is...
Need help?
Do you have a question about the EO710F and is the answer not in the manual?
Questions and answers