Electrical Safety - Black & Decker FX400 Original Instructions Manual

ENGLISH
• Never attempt to remove or
replace any parts other than
those specified in this manual.

Electrical safety

Before use, check that the mains
voltage corresponds to the voltage
on the rating plate
This appliance is double
insulated in accordance with
EN 60335-2-14; therefore no earth
wire is required.
To avoid the risk of electric
•
shock, do not immerse the cord,
plug or motor unit in water or
other liquid.
Check that the supply voltage
•
shown on the rating plate of the
appliance matches that of your
electrical system. Any connection
error will invalidate the guarantee.
Assembly
Wash all detachable parts (see chapter
'Maintenance and cleaning').
Assembling the food processor
• For the food processor fit the required
accessory blade (21, 22, 23 or 24) onto the
blade holder (20). Fit the assembled blade
holder into the food processor jug (19).
• Place the jug onto the food processor body (9)
by fitting it into the holder (8).
6
(Original instructions)
.
• Place the holder (27) on the motor coupling (8).
• Secure the jug by turning it anti-clockwise.
• Connect it to the electrical supply and select
the required speed using the rotary switch.
For the blender fit the jug seal (5) around the
base of the blender blade (7), place the blade (6)
into the blade holder (7) then place the blade
holder onto the blender jug base (4) (only
FX400BMG) .
For the mincer or grinder fit the jug seal (5) into
the required blade holder (14 or 17), then place
the blade holder (14 or 17) onto the required jug
base (12 or 15) (only FX400BMG).
Secure the blade holder (6, 14 or 17) by turning it
anti-clockwise (only FX400BMG).
Use
• Place the appliance on a flat stable surface.
• Put the ingredients into the required jug.
• If using the food processor fit the lid (25) onto
the jug (19) by turning it clockwise.
• If using the blender push the lid (2) and filler
cap (1) onto the jug (3) (only FX400BMG).
• If using the grinder or mincer seal the jug by
fitting the required blade holder (14 or 17) and
with the seal (5) and secure by turning anti-
clockwise) (only FX400BMG).
Note: When using the blender or mincer, the
correct lid must be fitted.
The following settings are available:-
P = Pulse Operation
O = Power Off
1 = Low Speed
2 = High Speed