Assembly Instructions - Newfire Cascade Owner's Manual

ASSEMBLY INSTRUCTIONS

1
Attach Right Side Cookstove Handle.
Attach G Wood Handle to stainless handle
by centering groove in wood on outside of handle
and fasten using two ½'' metal screws. Attach
handle to L Cookstove right side using two ¼-20
x ¼'' bolts and lock washers.
1
L
2
Insert Firepot. Place O Firepot with slanted
side towards the rear. Insert B Bottom Grate
into bottom slot of O Firepot. Insert Rod with Spring
Handle including 3/8'' Washer into rear slot on
heater and connect with nut on B Bottom Grate into
O Firepot. Pull Rod and make sure B Bottom Grate
slides out and pushes back all the way so that the
Bottom Grate is completely forward and sealed.
2 2 2 2 2
G
O
B
3
Install heater Door Hinge and doors.
Install heater U Door Hinge using two
10/32 x ½'' bolts side with nut at top. Using two
¼-20 x 1/2'' bolts secure each door to their Door
Hinges. Do not tighten all the way leaving room
for the door to open and close with ease. To
move door up and down for proper door latch
alignment tighten or loosen top and bottom
bolts accordingly.
3
4
Insert Glass into heater and Cookstove
Doors. Doors-Use the small black
retaining washers to hold glass flush to inside
wall. Push retaining washers tight to glass.
Banana Shape Retaining washers face curved
part towards stud.
4
5
Installing the Hopper. Place C Hopper
Brackets on left side of Heater and
connect using (2) 10/32 x ½'' bolts for the front
bracket and (1) 13/32 x 1/2 '' bolt for the rear
bracket. Slide Hopper chute into slot on side of
heater down through air chute inside of heater.
Insert F Hopper into C Hopper Brackets until
dropped into slots in bracket. Attach Hopper
flange using (4) 10/32 x ½'' bolts.
Cascade Complete Cookstove Owner's Manual
U
R
R
6