Assembly - Newfire Cascade Owner's Manual

ASSEMBLY

NOTE BEFORE ASSEMBLY:
Partial assembly has been done for you. Use
this assembly as an example for the remaining
parts. The assembly of this heater requires
basic mechanical skills. Proper assembly is the
responsibility of the purchaser. All service and
repairs should be done by a qualified person.
TOOLS REQUIRED FOR ASSEMBLY:
• Phillips Screwdriver
• Drill with Philips bit
• Cresent Wrench
UNPACKING:
Carefully remove the all parts from the box. The
paint on the heater is not fully cured until after
you fire the unit on its initial firing, so use care
when handling painted parts. Find and identify the
following parts found in "FIG. 1".
Also included in the box is a hardware bag containing the marked pieces to their corresponding parts:
CORRESPONDING HARDWARE
Use (2) ¼-20 x ¼'' bolts and lock
1. washers for attaching G handle to
Use 3/8'' Washer for connecting B Bottom
2.
Grate into O Firepot.
Use (2) 10/32 x ½'' bolts side with nut
3. at top. Use (2) ¼-20 x 1/2'' bolts secure
each door to their J Door Hinges.
Use (2) 10/32 x ½'' bolts for the front
bracket and (1) 13/32 x 1/2" bolt for the
4.
rear bracket. Attach Hopper flange
using (4) 10/32 x ½'' bolts.
Attach D Hopper Lid using (2) 10/32 x
5.
½'' bolts and lock nuts.
5 www.newfireoutdoors.com | 1-800-977-7344
L Cookstove.
WARNING
To ensure safe use of your outdoor
Cook Stove, you are requested to pay
close attention to these essential safety
requirements. This is a wood pellet,
direct-vented outdoor Cook Stove, all of
the combustion products leave the heater
from the chimney/smokestack. Byproducts
of combustion from this unit include carbon
monoxide. Carbon monoxide is toxic.
Carbon Monoxide can build up in a
heated space and failure to provide
adequate ventilation could result in
death. Always be sure there is plenty
of ventilation when the heater is in use.
Always follow the advice about ventilation
in these operating instructions.
Install G Hopper Handle using (2) ¼-20 x
7. ¾'' bolts inserted through holes
Use (2) 1/ 4 '' metal screws perrail and align
8.
over holes and tighten install T Brackets
Use (2) ½'' metal screws to attach
wooden handle to stainless handles. Use
(2) ¼-20 x 3/4'' bolts to place M Ash Pan
9.
front plate over L Ash Pan aligning over
holes. Use 1/4"-20 x 1/2" bolts to place G
handle over holes.
Fasten using two ½'' metal screws and
11. (2) ¼-20 X 1/2" bolts, ¼-20" lockwashers
and nuts to assemble hopper handles.
Use (3) 10/32 x 1/2" bolts for zerts on
Raincap brackets. attach bottom of
12.
bracket to raincap collar using (3) 10/32 x
½'' bolts and nuts through holes in collar.
on handle.