Turning Headset On/Off; Choosing Wearing Preference; Making A Call; Ending A Call - Jabra BT205 User Manual

BASIC OPERATIONS
5

Turning headset on/off

What you do
Turning Press and hold for 3 to
headset on 5 seconds until you see a
burst of flashes on the blue
indicator light, then release
Turning
Press and hold for 3 to
headset off
5 seconds until you see a
burst of flashes on the blue
indicator light, then release
Status indicators
What you see What you hear
Flashes every Quick series of 2 tones
second – low to high pitch (when
active mode starts)
Flashes every Quick series of 2 tones
3 seconds – high to low pitch (when
standby mode starts)
3 flashes every 3 beeps every 30 seconds
second
3 flashes every 3 beeps every 5 minutes
3 seconds
*
Depending on phone type and usage.
IMPORTANT: Do not hold the
turning the headset on or else it may go into pairing mode, and the blue indicator light
will turn solid. If that happens, turn off the headset, wait 3 to 5 seconds, and repeat
process for turning the headset on.
4
What you hear What you see
Ascending The blue indicator
(low-to-high) light will flash while
tones the power is on (see
Status indicators
table below)
Descending The blue indicator
(high-to-low) light will stop
tones flashing
Status
Active Mode⁵
•
Call in progress
•
Up to 3 hours of talk time*
Standby Mode⁶
•
Waiting for call
•
Up to 100 hours of
standby time*
Low Battery (in active mode)
•
3 – 5 minutes of talk time left
Low Battery (in standby mode)
•
3 – 5 minutes of talk time left
button down for more than 3 to 5 seconds when
6

Choosing wearing preference

Jabra BT205 is ready to wear on the right ear. If you prefer the left, gently rotate the
MiniGel 180°.
For optimal performance, wear Jabra BT205 and your Bluetooth phone on the same
side of your body. In general, you will get better performance when there are no
obstructions (including parts of your body) between the headset and the phone.
(see Fig. 4)
7

Making a call

If Jabra BT205 is off, turn it on now (see Turning headset on/off section).
Using phone's keypad
1. Dial number on keypad.
2. Press phone's "send" key.
Using voice-activated dialing (after you've set up voice tags on your phone)
1. Press and release once. You'll hear 1 short beep while doing this.
2. You'll then hear the voice-activation tone; say the name of the person you wish to call.
NOTE: Record voice tag from headset for better reception.
8

Ending a call

•
Press and release once.
OR
•
End call from phone's keypad.
9

Answering a call

•
After you hear the ring tone, press and release
OR
•
Answer the call with your phone's keypad. You may then need to transfer the call to
the headset by pressing and releasing once (depending on your phone).
once.
5