Connecting To Other Meridian Equipment - Meridian 586 User Manual

Connecting to other Meridian equipment

To connect to other Meridian 500
Series equipment
Connect one of the COMMS sockets on the back panel of the
DVD player to one of the COMMS sockets on another 500
Series unit, using the 500 comms lead provided with the 586
DVD Player.
The sequence in which you connect the units is not important.
586 DVD Player
COMMS
Then configure the units with the following automatic setup
procedure:
Switch all the units to standby.
Press CLEAR (remote).
Each unit will display:
60
One unit will then be designated
as the controller, and display:
This is the unit that will respond to the remote.
All the other units will be configured
as non-controllers, and display:
Your system is now set up and ready for use.
500 Series unit
COMMS
Note: Do not, under any circumstances, connect any equipment
other than Meridian 500, 600, or 200 Series to the socket
marked COMMS on the back of the DVD player.
Au to Se t u p
If for any reason the automatic setup does not give the
configuration you want, restore the default operation by
selecting one of the standard types; see Choosing standard
settings, page 48.
C o n t r o l l e r
N o t C o n .