Playing A Disc - Meridian 586 User Manual

Playing a disc

During normal use the DVD player should be left in the standby
state. This uses a negligible amount of electricity, but ensures
that the components of the DVD player operate at maximum
efficiency from the moment you start playing a disc.
If you are not going to use the DVD player for a period of several
days you should switch the unit completely off, at the back
panel, and disconnect it from the AC power supply.
To switch on from standby
Press Open (OPEN/CLOSE) or * (STOP).
Switch on any other equipment connected to the CD player
which is not part of the Meridian 500 Series.
The display will flash for a few seconds. The DVD player is then
ready for use.
To insert a disc
Press Open (front panel) or OPEN/CLOSE (remote) to open
the drawer.
IMPORTANT: Never touch the lenses which are accessible
when the drawer is open.
Place your disc, label side up, over the hub, as shown below.
IMPORTANT: Ensure that the disc is correctly seated on the
disc spindle before closing the drawer.
Press Open (OPEN/CLOSE) again or > (PLAY) to close the
drawer.
Most DVD videos start playing automatically when you close the
drawer.
Some DVD videos are double-sided, and need to be turned over
during play.
11