Technical Specifications - Evolite MOVING WASH 36x8Z User Manual

o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.

Some fixtures don't respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.

No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.


Technical Specifications

Model
Voltage
Power consumption:
LED
Gross Weight
Dimensions
MOVING WASH 36x8Z Manual Ver. 1.02
M 368Z QUAD ZOOM MOVING WASH
110V- 250V / 50-60Hz
380W
36x8pcs RGBW QUAD
9.5Kgs
39(H) x 39(W) x44(L) mm
DMX
Page 19