Installing The Unit - Kenwood DDX793 Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
❏ Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (eg, the sound may skip).
7
Reconnect the · battery.
8
Press the reset button. (Page 3)
9
Configure <Initial Setup>. (Page 4)

Installing the unit

❏ Installing the unit (only for DDX793/
·
DDX773BH/DDX593/DDX573BH/
DDX393/DDX373BT/DDX23BT)
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
❏ Installing the unit using the mounting
bracket removed from the car
5 or 6
• Select the appropriate type of screw for the
mounting bracket: flat head (5) or round head
(6).
❏ Installing the trim plate
1
Attach the trim plate (
Car Bracket
5 or 6
).
2
2
ENGLISH 67