Table of Contents
Advertisement
To improve tuner reception
When tuner reception is poor, set CD player
power off by the CD power manage function.
CD power is factory set to on.
1
Press CD (or FUNCTION on the unit
repeatedly) until "CD" appears.
2
Press ?/1 to turn off the system.
3
Press ?/1 while holding x.
"CD POWER OFF" appears.
To set CD power on
Repeat the procedure above and "CD POWER
ON" appears.
Notes
• When "CD POWER OFF" is selected, CD access
time is increased.
• You cannot change the setting in Power Saving
Mode.
To change the AM tuning interval
(except for Middle Eastern
model)
The AM tuning interval is factory-preset to 9
kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding TUNER/
BAND on the unit, press ?/1 on the unit. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
GB
16
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 15).
1
Press TUNER BAND repeatedly to
select "FM" or "AM".
2
Press PRESET +/– repeatedly to select
the desired preset station.
Preset number
Listening to non-preset radio
station
— Manual Tuning
1
Press TUNER BAND repeatedly to
select "FM" or "AM".
2
Press TUNING +/– repeatedly to tune in
the desired station.
Note
When "CD" is selected as the current function and
TUNER BAND is pressed to select "TUNER" during
"CD POWER OFF", it may take some time to switch
the function (page 16).
Frequency
Advertisement
Table of Contents
