Lowrance HDS Gen2 Touch Operator's Manual page 152

Shortening the cable
It is not recommended to shorten the cable, but if it is unavoidable, use the pin-out below to
re-terminate the cable with a new RJ45 plug.
RJ45 Connector pinout
P8
Required to complete
RJ45 Connector
Mounting the radar interface box
• Install the radar interface box (where applicable) in a dry location away from spray, rain,
drips and condensation
• The radar interface box must be located where it can be easily connected to the ship's
power source, the scanner interconnection cable, SimNet/NMEA2000 and the display or
display network
• Allow enough room for cables to form a drip loop
• Preferably mount the radar interface box on a vertical surface with cables exiting
downwards
• Insert connectors . See "Connect the interconnection cable to radar interface box" on page
12
• Secure to the surface using the four mounting points and supplied 8G x 5/8 pozi s/s fasters
Pin Color
1 White/Orange
P1
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
RJ45 Crimping tool
Installation | Broadband 3G/4G™ Radar Installation Guide
| 13