Listening To The Radio - Sharp MD-E9000H Operation Manual

Listening to the Radio

*07-E20-21-MD9000H(SEEG) 20
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button until "FM" or "AM" appears on
the display.
3
Press the TUNING ( X X X X X or W W W W W ) button on the remote control to tune
in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast
station.
Notes:
This can be operated by using the remote control only.
When radio interference occurs, auto scan tuning may stop automatically
at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING button on the remote control
again.
When an RDS (Radio Data System) station is tuned in, the frequency will
be displayed first, and then the RDS indicator will light. Finally, the station
name will appear.
Full auto tuning can be achieved for RDS stations (see "ASPM" on page 24).
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display "ST".
"j" will appear when an FM broadcast is in stereo.
FM stereo mode indicator
If the FM reception is weak, press the TUNER (BAND) button to extinguish "ST".
The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
01.4.19, 3:08 PM
MD-E9000H
FM stereo receiving indicator
E-20
D
F
S
V
I
N
E