Table of Contents
Advertisement
9) IDE3 / IDE4 (RAID/ATA133, Green Connector)
Important Notice: The red stripe of the ribbon cable must be the same side with the Pin1. If you wish
to use IDE3 and IDE4, please use it in unity with BIOS (either RAID or ATA133). Then, install the
correct driver to have proper operation. For details, please refer to the ITE RAID manual.
10) SATA0 / SATA1 (Serial ATA Connector)
You can connect the Serial ATA device to this connector, it provides you high speed transfer rates
(150MB/sec). If you wish to use RAID function, please note that these two Serial ATA connectors
just support RAID0 and only compatible with WinXP.
GA-8KNXP Ultra Motherboard
2
1
Pin No.
7
1
SATA1
7
1
SATA0
- 26 -
40
IDE4
IDE3
39
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
Advertisement
Table of Contents
