Malfunction And Indicator Lamps In The Instrument Cluster; On-Board Diagnostic System Check Engine Malfunction Indicator Lamp - Mercedes-Benz 2002 M-Class Operator's Manual

Instruments
Operation
and controls
Malfunction and indicator lamps
Malfunction and indicator lamps
in the instrument cluster
General information:
If a bulb in the instrument cluster fails to light up
during the bulb self-check when turning the key in
steering lock to position 2, have it checked and replaced
if necessary.
On-board diagnostic system
Check engine malfunction indicator lamp
Engine malfunction indicator lamp. If the
CHECK
"CHECK ENGINE" malfunction indicator
ENGINE
lamp comes on when the engine is running,
it indicates a malfunction of the fuel management
system, emission control system, systems which impact
emissions, or the fuel cap is not closed tight (check the
fuel cap). If the "CHECK ENGINE" lamp is illuminated
continuously and the vehicle is driving normally, you
may still drive the vehicle, however, in all cases, we
recommend that you have the system checked at your
authorized Mercedes-Benz Light Truck Center as soon
as possible.
If the "CHECK ENGINE" lamp comes on continuously
and/or the vehicle is not driving normally (e.g.
malfunction of the fuel management system or running
Instrument
Driving
cluster display
240
Practical hints Car care
out of fuel), serious damage can occur to the emission
system. Please contact your authorized Mercedes-Benz
Light Truck Center immediately.
The Sequential Multiport Fuel Injection (SFI) control
module monitors emission control components that
either provide input signals to or receive output signals
from the control module. Malfunctions resulting from
interruptions or failure of any of these components are
indicated by the "CHECK ENGINE" malfunction
indicator lamp in the instrument cluster and are
simultaneously stored in the SFI control module.
If the "CHECK ENGINE" malfunction indicator lamp
comes on, have the system checked at your authorized
Mercedes-Benz Light Truck Center as soon as possible.
With some exceptions, the control module switches off
the "CHECK ENGINE" malfunction indicator lamp if the
condition, causing the lamp to come on, no longer exists
during three consecutive cycles. See also page 242 for
fuel cap placement warning.
An on-board diagnostic connector is located in the
passenger compartment near to the parking brake
pedal, allowing the accurate identification of system
malfunctions through the readout of diagnostic trouble
codes.
Technical
Index
data